Guide

How to check road conditions before a drive

Updated October 26, 2026. General information from state DOT and 511 pages. Rules and signs change; on the road, the posted sign and the officer win.

Cameras, closures and winter conditions on one map, in the app

Every state's department of transportation publishes what it knows about its highways: closures, crashes, work zones, winter conditions and camera images. The trick is knowing which source answers which question, and checking close enough to when you leave that the answer still holds.

The four sources, and what each is good for

1. The 511 service

Most states run a 511 phone line and website (Colorado's is COtrip, Ohio's is OHGO, Washington's is the WSDOT site). It is the official record of closures, chain controls, incidents and planned work. If 511 says a road is closed, it is closed. Its weak spot is speed: a crash can take a while to appear and longer to clear from the list.

2. Road condition reports

In snow states, crews report the surface by segment: dry, wet, snow packed, icy, and whether a traction law or chain control is in force. These are the reports to read before a mountain pass. They are updated by people on patrol, so in a storm they can lag the weather by an hour or more. See the current reports for California, Colorado, Washington and Utah.

3. Traffic cameras

Cameras answer the question the reports cannot: what does it look like right now. Snow on the pavement, spray, a line of brake lights, a plow on the shoulder. Most state cameras send a new still image every one to a few minutes; check the time stamp before you trust one. More in how state traffic cameras work.

4. National Weather Service warnings

Winter storm warnings, blizzard warnings and high wind warnings tell you what is coming in the next hours, which neither 511 nor a camera can. A road that is fine at noon under a winter storm warning may not be at four.

A five-minute routine before you leave

  1. Closures first. Look for full closures and chain controls on your whole route, not just the first hour of it.
  2. Read the condition report for any pass or high stretch on the way.
  3. Look at the cameras at the worst points: summits, canyon mouths, river bridges, the interchange that always backs up.
  4. Check the warnings for the counties you will cross later in the day.
  5. Decide on a turnaround point. If the pass is at chain control when you reach the last town before it, where do you wait?

Check again close to departure. Conditions on a mountain pass can change within an hour, and closures are often lifted or added at shift changes and when plows finish a run.

Reading the map icons

State maps use similar symbols: a closure is a full stop for that direction; an incident is a crash, stalled vehicle or debris that may block a lane; a work zone usually has planned hours, so read them, since many are night only. A "lane closed" report on a two-lane road can mean flaggers and a long wait.

Where to look on this site

More guides

Traffic Cams & Road ConditionsCameras and closures on a live map
Get the app